You finally did it. It might be a few thousand miles past the little sticker in your window, but you finally went in for an oil change. Or, maybe you decided to take it upon yourself to change your own oil. However you went about it, with fresh oil and a new oil filter, your engine can breathe a sigh of relief. The only problem is now you still have that red “change oil” light illuminated on the dash board. You could go the way of your grandfather and just put a piece of black tape over the light, but that isn’t a great look. Thankfully, you don’t need to go to the dealership to have the light reset. The following steps are for resetting the change oil light for a newer model Ram pickup, but it should work for any later model Chrysler, Jeep or Dodge as well.
Turn Off “Change Oil” Light
To start, insert your key and set the ignition to “On.” Do not start the engine though. This will work for both current models, which use a chip based starter, and the more traditional metal key options of slightly older models.
With the ignition on, push down completely on the accelerator pedal. Do this slowly three times in a row within 10 seconds. When the pedal has come up following the third time, turn the ignition back to “Off.”
Now, turn the ignition and start the engine. Wait for all of the information to load up and for the dash to blink through its different computer and error indicators. The oil change light should now switch off. If it doesn’t, that could mean you did not have the ignition in the “On” position (if the RPMs shoot up while pushing down on the accelerator than you have gone past the “On” position). It may also mean you didn’t allow the accelerator pedal to fully depress and raise back up. Repeat the process until the light blinks off.
View Vehicle Codes
While you’re resetting the change oil light, wouldn’t it be nice to see if there are any other issues with the vehicle without taking it into the shop? Your car has a computer system that logs error codes whenever there is a problem. This can be anything from needing more coolant to problems with the transmission. You could purchase a computer program and a special connector to plug into the vehicle, but this is costly and unnecessary. Instead, you can simply check the vehicle error codes using a method similar to resetting the change oil light.
First, make sure you have a pad of paper and something to write with. The codes can flick through quickly, so if you have multiple codes it can be tough to remember.
Now, insert the key into the ignition. Flip it to the “On” position, then back off quickly. Do this three times in a row, leaving it in the “On” position on the third time.
In the middle of the dash, underneath the display information, messages and other context will flash through. If you have any error codes, the codes will appear here. The codes typically start with one or two letters, followed by a series of four or so numbers (for example, “PH2087“).
Write these codes down as each appears. If there are no error codes it will tell you there are no error codes.
Now, with the error codes written down, you can easily look up the codes on Google.
Often times, you can self-correct many of the problems, such as fluid levels or tire pressure. If you’re unsure about what the codes mean or how to fix them, contact Beckley Automotive. Our expert service department will help you determine what is urgent and what can wait, and then will make repairs using the most up-to-date technology and techniques.
Schedule your appointment online HERE today, call our service department at 515-243-8185, or visit our convenient downtown location at 901 8th Street, Des Moines.
Beckley Automotivehttp://beckleyauto.com/wp-content/uploads/2018/01/Beckleys-Automotive-Services-Logo.pngBeckley Automotive2017-01-25 14:30:562017-01-25 14:30:56How to Reset the Change Oil Light On a Newer Dodge